At present, the application of cationic polyacrylamide is more and more extensive. When choosing, be sure to pay attention to the ionicity of the product. If the ion degree is suitable, the final application value will be greater.
Cationic polyacrylamide is very common in sludge treatment. At present, a large number of enterprises consider the use of cationic polyacrylamide when dealing with sludge, and its application effect is really good. Among them, the application effect of product performance, component content and other aspects is very good, and the main components contained in it are also very different. Among them, organic There are some differences between sludge and inorganic sludge, which are very important to the human body, and the corresponding actual situation should also be considered.
Now, we must pay attention to the ionicity of cationic polyacrylamide for sludge dewatering treatment, to ensure that we can do a good job of screening, select the most suitable product, so that the flocculation effect is the best, and the corresponding application effect can also be appropriately reduced.
When selecting cationic polyacrylamide powder, the size and strength of the corresponding flocs should also be considered. If the floc is small, it will affect the final drainage rate. If the floc is too large, a large amount of water will be bound in it, which will eventually affect the drying of the mud cake. This affects us a lot. We must distinguish the difference, it will not have much impact on our specific operation.
After purchasing cationic polyacrylamide products now, we must pay attention to the mixing degree of cationic polyacrylamide products and sludge to ensure that the mixing degree is within the appropriate range. In this case, when we apply them, the pressure will be much less, and it will be of great help to everyone. We can also see the difference in its application, and the difference is still relatively large. We should fully consider this when purchasing cationic polyacrylamide powder products, and do our best to make the product quality meet our requirements.
Only the cationic polyacrylamide powder product has good solubility, the final product can play a good flocculation effect. We should speed up the corresponding dissolution speed under certain circumstances, so as to improve the final effect, and its application value will be higher.